Attention! Input results shown will be +/- 10% from middle value. Hint: The closer your min and max inputs are, the more accurate your results will be!

Attention! Input results shown will be +/- 10% from middle value. Hint: The closer your min and max inputs are, the more accurate your results will be!

Attention! Input results shown will be +/- 10% from middle value. Hint: The closer your min and max inputs are, the more accurate your results will be!

Attention! Input results shown will be +/- 10% from middle value. Hint: The closer your min and max inputs are, the more accurate your results will be!

Part Number System For Conical Compression Springs in Metric

StockSpringsCatalog.com Part Number System For Conical Compression Springs in Metric Millimeter

P

Part Number

CC

Conical Compression Spring

2413

Wire Diameter

-16256

Small Outer Diameter

-25400

Large Outer Diameter

-7000

Total Coils

-MW

Material Type

-38100

Free Length

-CG

End Type

-N

Finish

-MM

Unit of Measure

StockSpringsCatalog.com By Acxess Spring Part Number System In Metric For Conical Compression Springs

We have developed an easy stock spring part number system using the actual dimensions of the spring. This part number system for springs was developed to facilitate the creation and understanding of part numbers for springs. By using the actual dimensions of the spring in the spring part number we have made our part numbers for springs simple, but yet descriptive of the actual spring measurements in real time. Our part numbers consist of a series of numbers to describe each individual spring. Each part number is separated by hyphens to indicate different dimensional characteristics of a spring. Each series describes a different dimension. Below you will find a breakdown explanation of how The Spring Store part number system works for conical compression spring in millimeters.

  • The letter P stands for Part Number
  • The letter CC stands for Conical Compression Spring
  • The first series of numbers indicates Wire Diameter=WD
  • The second series, following the first hyphen, indicates Small Outer Diameter=SOD
  • The second series, following the first hyphen, indicates Large Outer Diameter=LOD
  • The third series, following the second hyphen, indicates Total Coils=TC
  • The fourth series, following the third hyphen, indicates Material Type
  • The fifth series, following the fourth hyphen, indicates Free Length=FL
  • The sixth series, following the fifth hyphen, indicates End Type
  • The seventh series, following the sixth hyphen, indicates Finish
  • The eighth series, following the last hyphen, indicates Unit of Measure Millimeters=MM

Please look at the part number example below for a further explanation.

Conical Compression Spring Part Number Example in Millimeters:

PCC2413-16256-25400-7000-MW-38100-CG-N-MM

  • P=Part Number
  • CC=Conical Compression Spring
  • 2413=2.413 Wire Diameter=WD
  • 16256=16.256 Small Outer Diameter=SOD
  • 25400=25.400 Large Outer Diameter=LOD
  • 7000=7.000 Total Coils=TC
  • MW=Material Type
  • 38100=38.100 Free Length=FL
  • CG=End Type
  • N=Finish
  • MM=Unit Of Measure Millimeters

Nomenclature:

Material Type: BC=Beryllium Copper, HD=Hard Drawn, MW=Music Wire, OT=Oil Tempered, PB=Phosphor Bronze, SST=Stainless Steel

End Type: C=Closed Ends, CG=Closed and Ground Ends, O=Open Ends

FinishBO=Black Oxide, GI=Gold Irridite, N=None, Z=Zinc

Unit of Measure: Millimeter=MM